DYNAMIC WAH DW400
Ultimate Auto-Wah/Human Voice Effects Pedal
Thank you for showing your confidence in us by purchasing the BEHRINGER DYNAMIC WAH DW400.
This effects pedal delivers a variety of wah effects including a Human Voice mode creating an
unbelievable “talking” sound. Experience exciting new sounds!
1. Controls
(1) Select the effect mode via the MODE switch:
(3)
(9)
(1)
UP: Creates a Wah effect. The filter moves
upwards (from low to high frequencies).
DOWN: Creates a Wah effect. The filter
moves downwards.
SYNTH: A stronger upward Wah effect with
a synth-like resonance filter sound.
HUMAN VOICE: Turns your instrument
signal into the sound of a human voice.
(4)
(2)
(6)
(8)
The sound alters between 2 selectable
vowel sounds and adds slight overdrive.
(5)
(7)
TEMPO: Auto Wah. Tap in the tempo via
foot switch (10) or external foot switch.
(2) SENS determines the effect sensitivity,
depending on the input level. In HUMAN
VOICE mode, it selects the first vowel.
In TEMPO mode, this control has
no function.
(10)
(3) The MANUAL control determines the wah
effects’ lowest frequency. In HUMAN VOICE mode, it selects the second vowel. In TEMPO mode,
this control has no function.
(4) The DECAY control determines how quickly the filter is shifted. In TEMPO mode, you can shape the
LFO waveform from Sine (min) to Square wave (max).
UP, DOWN, SYNTH
HUMAN VOICE
TEMPO
effect sensitivity,
depending on input level
Wah 1:
Selects the first vowel
SENS
no function
Wah 2:
Selects the second vowel
starting frequency
of Wah effect
MANUAL
DECAY
no function
Selects the Time used to
move from Wah 1 to Wah 2
LFO waveform shape:
Sine (Min) > Square (Max)
Envelope
Response Time
Fades between Wah 1 and
Wah 2 (DECAY disabled)
Wah pedal
(DECAY disabled)
Wah pedal (SENS, MANUAL
and DECAY disabled)
EXP/CTL*
*Connect an expression pedal (e.g. the FCV100) to the EXP/CTL connector
(5) The ¼" TRS EXP/CTL connector can be used to connect two different types of pedals:
•
•
Use an expression pedal for Wah pedal functionality (for all modes).
Use an external foot switch instead of the pedal foot switch ((10)) to tap in the effect time
(in Tempo mode only).
(6) Use the ¼" TS GTR IN connector to plug in a guitar. Use either input (6)or (7).
(7) Use the ¼" TS BASS IN connector to plug in a bass guitar. If you use this input, the filter parameters
are optimized for bass signals. With a cable in input (6), this input has no function.
(8) The ¼" TS OUT connector sends the signal to your amp or other effects devices.
FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE INFORMATION
DYNAMIC WAH DW400
Responsible Party Name:
Address:
MUSIC Group Services US Inc.
18912 North Creek Parkway,
Suite 200 Bothell, WA 98011,
USA
Phone Number:
Phone: +1 425 672 0816
Fax: +1 425 673 7647
DYNAMIC WAH DW400
complies with the FCC rules as mentioned in the following paragraph:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Important information:
Changes or modifications to the equipment not expressly approved by MUSIC Group can void
the user’s authority to use the equipment.
|