Specifications
Horizontal Coverage
120° max
93.7 %
0.8 kHz
Active Radiating Factor
Recommended Crossover (1)
Waveguide Material
Cast Aluminium
8 ohm
Nominal Impedance
Minimum Impedance
Nominal Power Handling (2)
Continuous Power Handling (3)
Sensitivity (1W/1m) (4)
Frequency Range (5)
Voice Coil Diameter
8.6 ohm
110 W
220 W
108 dB
0.5 -17 kHz
75 mm (3 in)
Aluminium
Composite
Polyimide/Titanium
1.85 T
Winding Material
Diaphragm Material
Flux Density
Mounting and Shipping Info
Waveguide Baffle Cutout
Driver diameter
Dimensions
153x25 mm (6x1 in)
124 mm (4.9 in)
163x130x235 mm
(6.4x5.1x9.3 in)
3.3 kg (7.3 lb)
Net Weight
Shipping Weight
Shipping Box
3.4 kg (7.5 lb)
245x140x175 mm
(9.6x5.5x6.9 in)
1
12 dB/oct. or higher slope high-pass filter.
2
2 hours test made with continuous pink noise signal (6 dB crest factor).
Power calculated on rated minimum impedance.
Power on Continuous Program is defined as 3 dB greater than the
Nominal rating.
3
Line Array Source
Line Array optimized Waveguide
Max. horizontal coverage 120°
220 W continuous program power capacity
75 mm (3 in) aluminium voice coil
Composite Polyimide/Titanium diaphragm
500 – 17000 Hz response
WG800
4
5
Applied RMS Voltage is set to 2.83V for 8 ohms Nominal Impedance.
Waveguide mounted on 90°x10° bell horn
108 dB sensitivity
|