Installation
Instructions
T970.702
DECK-MOUNT BATH FILLER TRIM KIT
with EverClean™ Finish
T970.712
T970.722
Congratulations on purchasing your American Standard
faucet with EverClean finish found only on American
Standard faucets.
T970.732
EverClean Finish
• One wipe effortlessly removes spots
• Eliminates the need for cleaners and scrubbing
• Permanent surface protectant remains beautiful
for the life of the faucet
Certified to comply with ANSI A112.18.1
U.S. Patent No. D403,750
M968652 Rev. 1.1
• EverClean™ available on: Polished Chrome, Satin Nickel,
Stainless Steel, Polished Brass (or any combination of these finishes)
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
Required tools
3
4
5
1
Phillips Screwdriver
Screwdriver
Drill with
3/16” bit
REMOVE ALL
BURRS AND
BEVEL
1
2
Hacksaw
Channel Locks
2
1"- 1-1/2"
FINISHED
DECK
SPOUT INSTALLATION
1
Complete FINISHED DECK before trim installation.
Turn off the water supplies.
Remove the GUARDS (1) from the VALVES (2). Remove the
GUARD (3) and 1/4" PLUG (4) from the SPOUT SHANK (5).
8.4mm
(21/64")
The SPOUT SHANK (5) height should be 1" to 1-1/2" above the
FINISHED DECK. Cut the SPOUT SHANK (5) if necessary. Remove all
burrs and bevel the end of the shank. Failure to do so may
damage the SPOUT O-ring during installation and cause water
leakage.
3/16" DIA. HOLE
18.6mm DIA.
19.8mm
(23/32")
Drill a 3/16" hole in the finished deck. See TEMPLATE for location.
(47/64")
SPOUT SHANK
SPOUT
SHANK
TEMPLATE FOR
SPOUT ROLL
PIN LOCATION
FRONT
6
11
8
3/16" DRILLED
HOLE
16
10
7
13
FINISHED
DECK
12
Lubricate the SPOUT ADAPTER O-RING (6) and
SPOUT O-RING (7).
15
9
Push SPOUT ADAPTER (8) on SPOUT SHANK (9)
and align slot in SPOUT ADAPTER (8) with 3/16"
drilled hole.
3/16" DRILLED
HOLE
Tighten SPOUT ADAPTER SET SCREW (10) securely
with 4mm HEX KEY (11).
Remove the PLUG BUTTON (12) from the SPOUT (13).
Position the RUBBER RING (14) in the groove in
the base of the SPOUT (13). Push the SPOUT (13) down
onto the SPOUT ADAPTER (8) and tighten the
8
SPOUT
O-RING
GROOVE
SET SCREW (15) securely with the 5mm HEX KEY (16).
14
13
Insert the PLUG BUTTON (12) into the SPOUT (13).
|