TDM-7 5 4 4
In-Dash Cassette/ Receiver/ CD Shuttle Controller
FEATURES
PWR
Tu n e r
MaxTune Tuner
DAP (Direct Access Preset)
REPEAT
CLOCK
DISP
DETACHABLE FRONT PANEL
M.I.X.
HEAD
FULL LOGIC CONTROL
VOL·BAS·TRE·BAL·FAD
CASSETTE RECEIVER
D. A.P.
1
2
3
TUNE
A.ME
MODE
LOUD
SOURCE
A.S.U.
BAND
PROG
B. SKIP
P.S. DN
P.S. UP
Auto Memory
Up/ Down Seek
Local/ DX Selection
Preset Address Indicator
4
5
6
CT
H
M
DN
UP
Ca sse tte
SmarTouch Powered Mechanism
Soft Loading/ Soft Eject
Ignition Key Off Pause
Auto Metal Tape Selector/ Indicator
SCC-II Tape Head
SPECIFICATIO N S
Programmable Music Sensor
Blank Skip
FM Tu n e r
Tuning Range ............................................................................... 87.7—107.9 MHz
Mono Usable Sensitivity .......................................................... 9.3dBf (0.8µV/ 75 ohms)
50dB Quieting Sensitivity ...................................................... 13.5dBf (1.3µV/ 75 ohms)
Alternate Channel Selectivity ............................................................................... 80dB
Signal-to-Noise (S/ N) ........................................................................................ 65dB
Stereo Separation ............................................................................................. 35dB
Capture Ratio .................................................................................................. 2.0dB
Repeat
Tape Play/ Pause
Tape In/ Run Indicator
CD Sh u ttle Co n tro l
Elapsed Time Display
Music Sensor (Skip)
Music Scan
MIX (Random Play)
Repeat (One/ All)
AM Tu n e r
Tuning Range ................................................................................... 530—1,710kHz
Usable Sensitivity (IEC Standard).......................................................... 22.5µV/ 27.0dB
Ca sse tte Pla y e r
Direct Disc Selection
Tape Speed .................................................................... 1-7/ 8ips (4.8cm/ sec) ±0.7%
Wow & Flutter ................................................................................................ 0.06%
Signal-to-Noise (S/ N) ........................................................................................ 60dB
Frequency Response (70 µs Metal Tape)......................................... 30Hz—20kHz (±3dB)
Stereo Separation ............................................................................................. 40dB
Ge n e ra l
35W x 4 High Power Amplifier
Control Center
Anti-Theft Detachable Front Panel
Detachable Trim Plate
ISO Mount Capability
Rear PreOut
Selectable Fader
Preamp Fader
Automatic Set-Up
Clock
Ge n e ra l
Maximum Power Output (Note 1) .............................................................. 35 watts x 4
Continous Power Output (Note 2) ............................................................... 15watts x 4
Pre Output Voltage (Before Clipping) ................................................................... 2 volts
Bass Control Range ............................................................................ ±15dB at 30Hz
Treble Control Range ......................................................................... ±10dB at 10kHz
Loudness Control ............................................................................. ±10dB at 100Hz
Operating Temperature ................................................... 60°C (140°F) to -10°C (14°F)
Power Requirement.................................................. 11—16 volts DC (Negative Ground)
Maximum Mounting Angle ................................................................. 45° of Horizontal
Chassis Size (W x H x D) ...................................... 178mm x 50mm x 152mm (7"x2"x6")
Nose Piece Size (W x H x D) ......... 170mm x 46 mm x 18mm (6-3/ 4"x1-13/ 16"x11/ 16")
Weight .......................................................................................... 1.4Kg(3lbs. 1 oz)
Source Tone Memory (STM)
Bass & Treble Controls
Fader & Balance Controls
Loudness
Note 1: Under maximum operating voltage and input signal, into 4 ohm loads.
Note 2: Per EIA-517 standard,40Hz to 20kHz, 0.8% THD, with 14.4 volt DC supply
Specifications and design are subject to change without notice
|