Vandal Resistant Sub Stations for LAF-C, LEF, LEM, AP-M, MP-S Systems
- INSTRUCTIONS -
The LE-SS and LE-SSR are 2-gang stainless steel vandal proof and weather resistant sub stations designed for use
with the systems listed above. They are constructed with 12 gauge stainless steel, and the LE-SSR features a red
mushroom call button. The units either flush mount into a 2-gang box, or surface mount with the SBX-2G. Each unit
includes tamper proof screws and a tool for installation.
INSTALLATION:
1. For flush mounting, install sub station in standard 2-gang electrical box with min. 2-1/2" depth.
2. For surface mounting, install sub station in the SBX-2G surface mount enclosure.
3. IMPORTANT! These units are designed for use in normal weather conditions, and to allow drainage and
evaporation of moisture that naturally gets into the unit. Do not apply caulking or silicone sealant around the
unit when installing, and do not use weather stripping around the perimeter of the box when mounting. If
sealing the unit is required, the bottom must remain unsealed. Sealing the unit will prevent or inhibit moisture from
dissipating from inside the unit, which may cause corrosion or deterioration to the internal components over time.
MOUNTING:
2-GANG BOX
LE-SS
LE-SSR
TORX
screws
WIRING DIAGRAMS:
Do not apply sealant
between unit and box.
LEM SYSTEM:
LEM Master
LE-SS(R) Sub
1
E
Red
Blk*
Blu
Power
Source*
Jumper Blue & Black
wires together.
*LEM-1 or LEM-3: Use SKK-620
(6V DC)
+
-
+
-
LEM-1DL: Use PT-1210N
(or any source providing 12-16V
AC or 12-24V DC)
LEF SYSTEM:
LEF, LAF/LDF
Master Station*
LE-SS(R) Sub
LE-SS(R) Sub
Red
1
2
Red
~
10
PS-1225UL
Blk*
Blu
E
+
-
Blk*
* In single master LEF system
only, 2 conductors homerun can
be used with the BLK and BLU
wires tied together and "E" and
"-" jumpered at the master.
+
-
Blu
Page 1
|