KC-IFA
Network Video Interface Adaptor
KCS-IFA Set includes:
KC-IFA, KC-DAR, PS-2420UL
- INSTRUCTIONS -
The KC-IFA is a network video interface adaptor that allows the Aiphone color video door station to be connected
through a video server (not supplied by Aiphone) to any PC connected to a LAN or WAN network. This provides
audio and video identification and access control for a person at the camera location, answered from a PC.
DOOR STATION INSTALLATION:
1. The KC-DAR should be mounted between 48-52" above finished floor, or at optimum height for the application.
(See illustrations below.)
2. Install KC-DAR to 1-gang box or ring, or directly to wall surface with appropirate hardware.
3. Use 2 conductor, 18AWG non-shielded wire from KC-DAR to KC-IFA. (Aiphone #871802)
Mounting height
Back frame
Single-gang box
250cm (8'3")
130cm (4'3")
KC-DAR
83.5mm
(3-5/16")
Unit
center
150cm (5')
50cm
(20")
Screws supplied (2)
Tamperproof
screw & cover
The KCS-IFA System interfaces with a Network Video Server.
Aiphone has evaluated and approved the following manufactures’ products for use with the KC-IFA:
BRAND:
Inscape Data
MODEL:
NVS-410
NOTES:
NVS-410
VIP10
Two relay outputs (One for door release)
Software Included
VCS VIP 10
One relay output for door release
NOTE: RS232 programmable relay controller can be interfaced with most video servers to control
The Tilt function of the video door station. Contact Technical Support for more information.
SPECIFICATIONS:
Power Source:
Consumption
Video Out:
Audio In:
Audio Out:
TERMINAL DEFINITIONS:
24VDC, 1A
400mA, Max.
NTSC, 1Vp-p
10k Ohm
A1/A2:
+/-:
KC-DAR Connection
DC 24V Input
BNC Connector: Video Output
NO,NC,COM:
OUT/GND:
IN/GND:
UP:
DN:
GND:
Call-in Output
Audio Output
Audio Input
Tilt Control Up (“Lo” active)
Tilt Control Down (“Lo” active)
Tilt Control Ground
600 Ohm
Call-in Signal:
N/O – COM – N/C, 24V DC@ 1A
(Present at .5 sec.; adjustable to 30 sec.)
TTL/CMOS low level control
4.3 lbs
1.7"H x 7.9"W x 9"D
2 parallel wires, non-polarized (#871802)
22 AWG = 165', 18 AWG = 330'
Tilt Up/Down:
Weight:
Dimensions:
KC-DAR to KC-IFA:
Pg. 1
FCC Class B Verification
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device , pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try and correct the interference by one or more of the following measures:
— Reorient or locate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Aiphone Communication Systems
TOLL FREE TECHNICAL SUPPORT
(800) 692-0200
1700 130th AVE NE
Bellevue, WA 98005
(425) 455-0510
TOLL FREE FAX LINE
(800) 832-3765
Pg. 3
KC-IFA Inst.
1005JD
FAX (425) 455-0071
E-MAIL: [email protected]
|