8 Port 10/100/1000Mbps Gigabit
Switch
Quick Installation Guide
Model# ANS-800P
General Description
Advantek Networks ANS-800P is a high-performance Gigabit Ethernet Switch with all 8 ports
capable of 10, 100 and 1000Mbps auto-negotiation operation. The Gigabit switching hub
supports Quality of Service (QoS), 8021Q and RMON counters. All ports support IEEE
802.1Q VLAN, Spanning Tree and isolated WAN vs. LAN firewall applications.
The Gigabit switching hub provides non-blocking switching performance in all traffic
environment that all packets are directed into one of four traffic class queues based upon port,
IEEE 802.1p, Ipv4’s TOS or Diff-Serv, Ipv6’s Traffic Class, 802.1Q VID, DA MAC address or
SA MAC address. Back-pressure and pause frame-based flow control schemes are included
to support zero packet loss under temporary traffic congestion.
Product Features
•
•
•
•
•
•
•
•
•
•
Supports Auto MDIX.
Fixed priority & programmable weighted fair queuing.
Compliant with IEEE 802.3, IEEE 802.3u, and IEEE 802.3x.
Supports Store-and-forward operation.
Each port works at 10 Mbps or 100 Mbps, full or half duplex mode.
Automatic speed and duplex communication between the
Back-pressure flow control on half duplex ports & Pause-ports.
Shared 1 Mbit on-chip memory-based switch fabric performance.
Embedded 128K Byte SRAM for packet buffer.
Supports port-based trunking for high-bandwidth links.
Package contents
•
•
•
One 8 Port Gigabit switching hub
One 12V 1.5A DC adapter
One 8 Port Gigabit Switching Hub User’s Quick Guide
*
If any of the items is damaged or missing, please contact your retailer immediately.
Front panel LED indicators
After installing the switch, you can check its status from the LED indicators on the front panel
shown below.
Front View
Rear panel ports
Back Panel
Ports 1x - 8x :The switch has eight 10/100/1000Mbps RJ-45 ports where you can connect
computers or network devices to the switch.
Power Connecting
Plug the circle end of the power adapter firmly into the power port on the switch rear panel, and
the other end into an electric service outlet, then the system is ready.
Connecting computers to the switch
The switch features auto-MDI/MDIX crossover detection function and provides plug-and-play
capability. Users can immediately use any of the features of this product simply by plugging the
network cables (RJ-45) into the computers and the switch.
Uplink
All Ports can be used as an uplink port for connecting to another unit without using crossover
cable. When using the uplink port, you can extend the distance to 100m for linking another switch
or hub.
To prolong the operational life of your units
*Never stack units more than eight high if freestanding
*Do not place objects on top of any unit or stack
*Do not obstruct any vents at the sides of the case
*Use only the AC power adapter that came with the
switch to prevent damage to the unit.
|